Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

73-6 Fabric OS Message Reference
Publication Number: 53-1000242-01
ZONE-1018
73
ZONE-1018
Message
Probable
Cause
Indicates that an incorrect zoning enforcement type was reported on the specified port. This is a
software error. A QuickLoop zone type (value = 4) or an uninitialized type (value = 0) are invalid. The
valid zone type values are:
• hard port zone (value = 1)
• hard wwn zone (value = 2)
• session based hard zoning (value = 3)
• FA zone (value = 5)
QuickLoop zones are not supported in Fabric OS v4.x.
Recommended
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
ZONE-1019
Message
Probable
Cause
Indicates that the Reliable Commit Service (RCS) had a transmit error. RCS is a protocol used to
transmit changes to the configuration database within a fabric.
Recommended
Action
Often this message indicates a transitory problem. Wait a few minutes and retry the command.
Make sure that your changes to the zone database are not overwriting the work of another admin.
Run the cfgTransShow command to find out if there is any outstanding transaction running on the local
switches.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
<timestamp>, [ZONE-1018], <sequence-number>,, ERROR, <system-name>,
Incorrect zoning enforcement type(<zone type>) at port(<port
number>)
<timestamp>, [ZONE-1019], <sequence-number>,, ERROR, <system-name>,
Transaction Commit failed. Reason code <reason code> (<Application
reason>) - \"<reason string>\"