Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 1-5
Publication Number: 53-1000242-01
Viewing and Configuring System Message Logs
1
portLogShowPort Displays the port log of specified port, with page breaks.
portLogTypeDisable Disables an event from reporting to the port log. Port log events are described
by the portLogEventShow command.
portLogTypeEnable Enables an event to report to the port log. Port log events are described by the
portLogEventShow command.
saveCore Saves or removes core files created by the kernel.
setVerbose Sets the verbose level of a particular module within the Fabric OS.
supportFtp Sets, clears, or displays support FTP parameters or a time interval to check the
FTP server.
supportFfdc Enables and disables FFDC (first failure data capture).
supportSave Collects RASLog, trace files, and supportShow (active CP only) information
for the local CP and then transfers the files to an FTP server. The operation can
take several minutes.
supportShow Executes a list of diagnostic and error display commands. This output is used
by your switch service provider to diagnose and correct problems with the
switch. The output from this command is very long.
syslogDIpAdd Adds an IP address as a recipient of system messages.
syslogDIpRemove Removes an IP address as a recipient of system messages.
syslogDIpShow Views the currently configured IP addresses that are recipients of system
messages.
syslogdFacility Changes the syslogd facility.
traceDump Displays, initiates, or removes a Fabric OS module trace dump.
traceFtp Displays, enables, or disables the trace auto-FTP or retrieves the trace dump
file.
traceTrig Sets, removes, or displays trace triggers.
Table 1-1 Commands Used to View or Configure the System Logs (Continued)
Command Description