Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 2-3
Publication Number: 53-1000242-01
AUTH-1007
2
Probable
Cause
Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WAR NIN G
AUTH-1007
Message
Probable
Cause
Indicates that the proposed authentication protocol type or types are not supported by the local specified
port.
Recommended
Action
Run the authUtil command to make sure the local switch supports the specified protocols: FCAP or
DH-CHAP.
Severity ERROR
AUTH-1008
Message
Probable
Cause
Indicates that the switch does not have a security license.
Recommended
Action
Verify that the security license is installed using the licenseShow command. If necessary, reinstall the
license using the licenseAdd command.
Severity ERROR
AUTH-1010
Message
<timestamp>, [AUTH-1007], <sequence-number>,, ERROR, <system-name>,
The proposed authentication protocol(s) are not supported: port
<port number>.
<timestamp>, [AUTH-1008], <sequence-number>,, ERROR, <system-name>,
No security license, operation failed.
<timestamp>, [AUTH-1010], <sequence-number>,, ERROR, <system-name>,
Failed to initialize security policy: switch <switch number>, error
<error code>.