Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 2-5
Publication Number: 53-1000242-01
AUTH-1013
2
AUTH-1013
Message
Probable
Cause
Indicates that the system is running low on resources when receiving an authentication request.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WAR NIN G
AUTH-1014
Message
Probable
Cause
Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1017
Message
Probable
Cause
Indicates an internal problem with the Secure Fabric OS.
<timestamp>, [AUTH-1013], <sequence-number>,, WARNING, <system-
name>, Can not perform authentication request message: port <port
number>, message code <message code>
<timestamp>, [AUTH-1014], <sequence-number>, FFDC, ERROR, <system-
name>, Invalid port value to <operation>: port <port number>
<timestamp>, [AUTH-1017], <sequence-number>,, ERROR, <system-name>,
Invalid value to start authentication request: port <port number>,
opcode <operation code>