Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

2-6 Fabric OS Message Reference
Publication Number: 53-1000242-01
AUTH-1018
2
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1018
Message
Probable
Cause
Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1020
Message
Probable
Cause
Indicates that an authentication message's timer was not created.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity INFO
<timestamp>, [AUTH-1018], <sequence-number>,, ERROR, <system-name>,
Invalid value to check protocol type: port <port number>
<timestamp>, [AUTH-1020], <sequence-number>,, INFO, <system-name>,
Failed to create timer for authentication: port <port number>