Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 2-7
Publication Number: 53-1000242-01
AUTH-1022
2
AUTH-1022
Message
Probable
Cause
Indicates the authentication process failed to extract a particular value from the receiving payload.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1023
Message
Probable
Cause
Indicates an authentication operation failed for a certain authentication phase.
Operation type varies depending on authentication type:
• Some operations for SLAP: certificate retrieve, certificate verification signature verification, or
nonce signing.
• Some operations for FCAP: certificate retrieve, certificate verification, signature verification, or
nonce singing.
• Some operations for DH-CHAP: response calculation, challenge generation, or secret retrieve.
The authentication phase specifies which phase of a particular authentication protocol failed.
A nonce is a single-use, usually random value used in authentication protocols to prevent replay attacks.
Recommended
Action
The error might indicate that an invalid entity tried to connect to the switch. Check the connection port
for possible unauthorized access attack.
It might indicate that the PKI object for SLAP or FCAP or secret value for DH-CHAP on the local
entity is not set up properly. Reinstall all PKI objects or reset the secret value for DH-CHAP properly.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
<timestamp>, [AUTH-1022], <sequence-number>,, ERROR, <system-name>,
Failed to extract <data type> from <message> payload: port <port
number>.
<timestamp>, [AUTH-1023], <sequence-number>,, ERROR, <system-name>,
Failed to <operation type> during <authentication phase>: port
<port number>.