Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

2-12 Fabric OS Message Reference
Publication Number: 53-1000242-01
AUTH-1036
2
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1036
Message
Probable
Cause
Indicates that the switch received an unexpected authentication message.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1037
Message
Probable
Cause
Indicates that a DH-CHAP authentication operation failed on the specified port due to mismatched
response values between two entities.
Recommended
Action
The error might indicate that an invalid entity tried to connect to the switch. Check the connection port
for a possible security attack.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
<timestamp>, [AUTH-1036], <sequence-number>,, ERROR, <system-name>,
Invalid state <state value> for <authentication phase>: port <port
number>
<timestamp>, [AUTH-1037], <sequence-number>,, ERROR, <system-name>,
Failed to <operation type> response for <authentication message>:
init_len <data length>, resp_len <data length>, port <port number>.