Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 3-3
Publication Number: 53-1000242-01
BL-1006
3
BL-1006
Message
Probable
Cause
Indicates that the errors (mostly synchronization errors) on this blade are harmless. Probably, the
standby CP blade connected to the active CP blade has experienced transitory problems.
Recommended
Action
Verify that the standby CP is healthy. If the standby CP was removed or faulted by user intervention, no
action is required.
Severity INFO
BL-1007
Message
Probable
Cause
Indicates that a failover occurred while a blade was initializing on the previously active CP.
Recommended
Action
No action is required. The blade is reinitialized. Because reinitializing a blade is a disruptive operation
and can stop I/O traffic, you might have to stop and restart the traffic during this process.
Severity WAR NIN G
BL-1008
Message
Probable
Cause
Indicates that the blade has experienced a hardware failure or was removed without following the
recommended removal procedure.
Recommended
Action
Make sure that the blade is seated correctly.
If the blade is seated correctly, reboot or power cycle the blade.
Run the systemVerification command to verify that the blade does not have hardware problems. Refer
to the Fabric OS Command Reference for more information on this command.
<timestamp>, [BL-1006], <sequence-number>,, INFO, <system-name>,
Blade <slot number> NOT faulted. Peer blade <slot number>
experienced abrupt failure.
<timestamp>, [BL-1007], <sequence-number>,, WARNING, <system-name>,
blade #<blade number>: blade state is inconsistent with EM.
bl_cflags 0x<blade control flags>, slot_on <slot_on flag>, slot_off
<slot_off flag>, faulty <faulty flag>, status <blade status>
<timestamp>, [BL-1008], <sequence-number>, FFDC, CRITICAL, <system-
name>, Slot <slot number> control-plane failure. Expected value:
0x<value 1>, Actual: 0x<value 2>