Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 3-5
Publication Number: 53-1000242-01
BL-1012
3
Probable
Cause
Indicates that too many interrupts in the embedded port caused the specified chip to be disabled. The
probable cause is too many abnormal frames; the chip is disabled to prevent the CP from becoming too
busy.
Recommended
Action
Make sure to capture the console output during this process.
Check for a faulty cable, SFP, or device attached to the specified port.
Run the systemVerification command to verify that the blade or switch does not have hardware
problems.
On a bladed switch, run the slotPowerOff and slotPowerOn commands.
On a nonbladed switch, reboot or power cycle the switch.
If the message persists, replace the blade or the nonbladed switch.
Severity CRITICAL
BL-1012
Message
Probable
Cause
Indicates that the port generated an excessive number of interrupts that might prove fatal to the switch
operation. The port is disabled to prevent the CP from becoming too busy. The bport is the blade port;
this number might not correspond to a user port number.
Recommended
Action
Make sure to capture the console output during this process.
Check for a faulty cable, SFP, or device attached to the specified port.
On a bladed switch, run the slotPowerOff and slotPowerOn commands.
On a nonbladed switch, reboot or power cycle the switch.
If the message persists, replace the blade or the nonbladed switch.
Severity ERROR
BL-1013
Message
Probable
Cause
Indicates that the port generated an excessive number of interrupts that might prove fatal to the switch
operation. The port is disabled to prevent the CP from becoming too busy. The bport is the blade port;
this number might not correspond to a user port number.
<timestamp>, [BL-1012], <sequence-number>,, ERROR, <system-name>,
bport <port number> port int. is disabled. status=0x<interrupt
status> Port <port number> will be re-enabled in 1 minute.
<timestamp>, [BL-1013], <sequence-number>,, ERROR, <system-name>,
bport <port number> port is faulted. status=0x<interrupt status>
Port <port number> will be re-enabled in 1 minute.