Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 15

53-1002448-01

Displaying and clearing system message logs

This section provides information on viewing and clearing RASLog messages. These procedures are

valid for all the supported platforms.

Viewing RASLog messages from Web Tools

To view the system message log for a switch from Web Tools, perform the following steps.

1. Launch Web Tools.

2. Select the desired switch from the Fabric Tree. The Switch View displays.

3. Click the Switch Events tab. You can view the switch events and messages in the Switch Events

Report displayed.

In dual-domain switches, an Event button exists for each logical switch. Only messages relating to

that switch (and chassis) will be displayed.

Displaying RASLog messages

To display the system message log with no page breaks, perform the following steps.

1. Log in to the switch as admin.

2. Enter the errDump command at the command line.

switch:admin> errdump

Version: 7.0.1

2000/12/17-05:54:30, [HAM-1004], 1, CHASSIS, INFO, switch, Processor rebooted

- Reset

2000/12/17-05:55:04, [ZONE-1034], 2, FID 128, INFO, switch, A new zone

database file is created.

2000/12/17-05:55:04, [FCR-1069], 3, FID 128, INFO, switch, The FC Routing

service is enabled.

2000/12/17-05:55:04, [FCR-1068], 4, FID 128, INFO, switch, The FC Routing

service is disabled.

2000/12/17-05:55:11, [EM-1034], 5, CHASSIS, ERROR, switch, PS 2 set to faulty,

rc=2000e.

[...]

syslogdFacility Changes the syslogd facility.

syslogdIpAdd Adds an IP address as a recipient of system messages.

syslogdIpRemove Removes an IP address as a recipient of system messages.

syslogdIpShow Views the currently configured IP addresses that are recipients of system messages.

traceDump Displays, initiates, or removes a Fabric OS module trace dump.

TABLE 3 Commands for viewing or configuring the system parameters and message logs (Continued)

Command Description