Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

16 Fabric OS Message Reference
53-1002448-01
Displaying, clearing, and configuring Audit messages
1
Displaying RASLog messages one message at a time
To display the system message log one message at a time, perform the following steps.
1. Log in to the switch as admin.
2. Enter the errShow command at the command line.
switch:admin> errshow
Version: 7.0.1
2011/11/11-05:54:30, [HAM-1004], 1, CHASSIS, INFO, switch, Processor rebooted
- Reset
Type <CR> to continue, Q<CR> to stop:
2011/11/11-05:55:04, [ZONE-1034], 2, FID 128, INFO, switch, A new zone
database file is created.
Type <CR> to continue, Q<CR> to stop:
2011/11/11-05:55:04, [FCR-1069], 3, FID 128, INFO, switch, The FC Routing
service is enabled.
Type <CR> to continue, Q<CR> to stop:
Clearing the system message log
To clear the system message log for a particular switch instance, perform the following steps.
1. Log in to the switch as admin.
2. Execute the errClear command to clear all messages from memory.
NOTE
For products that have a single processor, all error log messages are cleared. For products that have
multiple processors, this command only clears the error logs of the processor from which it is
executed.
Displaying, clearing, and configuring Audit messages
This section provides information on viewing, clearing, and configuring Audit messages. These
procedures are valid for all the supported platforms.
Displaying Audit messages
To display the Audit messages, perform the following steps.
1. Log in to the switch as admin.
2. Enter the auditDump -s command at the command line.
switch:admin> auditdump -s