Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

42 Fabric OS Message Reference
53-1002448-01
AG-1025
2
Recommended
Action
Execute the ag --mapShow command to display the updated F_Port-to-N_Port mapping.
Severity INFO
AG-1025
Message <timestamp>, [AG-1025], <sequence-number>,, ERROR, <system-name>, Port group of
Slave N_Port <port> is different than its Master N_Port <m_port>.
Probable Cause Indicates that the port groups of the Master and Slave N_Ports are different while the Trunk Area
assigned to the attached F_Ports on the edge switch is the same.
Recommended
Action
Execute the porttrunkarea
--show command on the attached switch to display that the Trunk Area
is assigned to all ports in the system and execute the porttrunkarea
--enable command to
reconfigure the Trunk Area.
Severity ERROR
AG-1026
Message <timestamp>, [AG-1026], <sequence-number>,, WARNING, <system-name>, Unable to
handle the login request on port <port> due to insufficient resources.
Probable Cause Indicates that there are insufficient resources.
Recommended
Action
Execute the configure command on the Access Gateway switch and increase the number of
allowed logins on this port.
If the message persists, execute the supportFtp (as needed) to set up automatic FTP transfers;
then execute the supportSave command and contact your switch service provider.
Severity WARNING
AG-1027
Message <timestamp>, [AG-1027], <sequence-number>,, WARNING, <system-name>, Unable to
handle this login request on port <port> because NPIV capability is not enabled on
this port.
Probable Cause Indicates that N_Port ID virtualization (NPIV) is not enabled.
Recommended
Action
Execute the portcfgnpivport command on the Access Gateway switch and enable the NPIV
capability on this port.
Severity WARNING