Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

72 Fabric OS Message Reference

53-1002448-01

BL-1003

Message <timestamp>, [BL-1003], <sequence-number>, FFDC, CRITICAL, <system-name>,

Faulting blade in slot <slot number>

Probable Cause Indicates a faulty blade in the specified slot number.

Recommended

Action

Make sure that the blade is seated correctly. If the blade is seated correctly, restart or power cycle

the blade.

Run the diagPost command to ensure that Power-On Self-Test (POST) is enabled. Refer to the Fabric

OS Command Reference for more information on these commands.

If the message persists, replace the blade.

Severity CRITICAL

BL-1004

Message <timestamp>, [BL-1004], <sequence-number>, FFDC, CRITICAL, <system-name>,

Suppressing blade fault in slot <slot number>

Probable Cause Indicates that the specified blade experienced a failure but was not faulted due to a user setting.

Recommended

Action

Restart or power cycle the blade, using the slotPowerOff and slotPowerOn commands.

Run the diagPost command to ensure that Power-On Self-Test (POST) is enabled. Refer to the Fabric

OS Command Reference for more information on these commands.

If the message persists, replace the blade.

Severity CRITICAL

BL-1006

Message <timestamp>, [BL-1006], <sequence-number>,, INFO, <system-name>, Blade <slot

number> NOT faulted. Peer blade <slot number> experienced abrupt failure.

Probable Cause Indicates that the errors (mostly synchronization errors) on this blade are harmless. Probably, the

standby control processor (CP) blade connected to the active CP blade has experienced transitory

problems.

Recommended

Action

Use the haShow command to verify that the standby CP is healthy. If problem persists remove and

reinstall the faulty blade.

Severity INFO