Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 93

53-1002448-01

BM-1007

Message <timestamp>, [BM-1007], <sequence-number>,, INFO, <system-name>, If set, clear

EX/VEX/FC Fastwrite configuration for all ports for blade in slot <Slot number>

Probable Cause Indicates the specified blade was detected for the first time after an FR4-18i was previously

configured in the same slot. The new blade requires the specified port configurations to be cleared.

Recommended

Action

No action is required. The blade ports are cleared automatically.

Severity INFO

BM-1008

Message <timestamp>, [BM-1008], <sequence-number>,, WARNING, <system-name>, Download of

blade firmware failed for blade in slot <slot>

. Reissue firmwaredownload to

recover.

Probable Cause Indicates the automatic firmware upgrade on the blade has failed, because the blade firmware

version was detected to be different from the control processor (CP) firmware version due to a

firmware upgrade.

Recommended

Action

Issue the firmwareDownload command to recover the blade.

Severity WARNING

BM-1009

Message <timestamp>, [BM-1009], <sequence-number>,, WARNING, <system-name>,

Firmwaredownload timed-out for application processor. Faulting switch.

Probable Cause Indicates the firmwareDownload on the application processor (AP) blade failed.

Recommended

Action

Use the slotPowerOff and slotPowerOn commands or reseat the affected blade. On the Brocade

7500 or 7600, switch off and switch on all primary power in order to power-cycle the unit.

Severity WARNING

BM-1010

Message <timestamp>, [BM-1010], <sequence-number>,, INFO, <system-name>, Resetting port

configuration and linkcost for all ports for blade in slot <Slot number>.

Probable Cause Indicates the specified blade was detected for the first time after an FC10-6 was previously

configured in the same slot. The new blade requires resetting the port configuration and linkcost.