Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 195
53-1002448-01
EM-1062
25
EM-1062
Message <timestamp>, [EM-1062], <sequence-number>,, CRITICAL, <system-name>, Blade in
slot <Slot Id> faulted as it exceeds the maximum support limit of <Limit> blades
with Blade ID <Blade Type Id> in the chassis.
Probable Cause Indicates that too many blades of a particular type are in the system.
Recommended
Action
Remove the faulted blade.
Severity CRITICAL
EM-1063
Message <timestamp>, [EM-1063], <sequence-number>,, CRITICAL, <system-name>, Blade in
slot <Slot Id> faulted because it exceeds the maximum support limit of <Limit>
blades with Blade IDs <Applicable blade Type IDs> in the chassis.
Probable Cause Indicates that too many blades of a set of particular types are in the system.
Recommended
Action
Remove the faulted blade.
Severity CRITICAL
EM-1064
Message <timestamp>, [EM-1064], <sequence-number>,, CRITICAL, <system-name>, Blade:<slot
ID> is being powered off (based on user configuration) upon receiving a HW ASIC
ERROR, reason:<Fault reason>.
Probable Cause Indicates the blade is being powered off because a hardware (HW) application-specific integrated
circuit (ASIC) error was detected, and you have selected to power off the problem blade when such
a condition occurred.
Recommended
Action
Contact your switch service provider for assistance.
Severity CRITICAL
EM-1065
Message <timestamp>, [EM-1065], <sequence-number>,, WARNING, <system-name>, SAS
Virtualization Services are not available due to incompatibility between the FOS
and SAS versions<Slot number or blank for single board systems>.
Probable Cause Indicates that the version of the control processor firmware (CFOS) or the blade processor firmware
(BFOS) is incompatible with the Storage Application Services (SAS) or other application firmware
versions.