Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

220 Fabric OS Message Reference

53-1002448-01

FABR-1040

Message <timestamp>, [FABR-1040], <sequence-number>, INFO, <system-name>, Speed is not

2g,4g or 8g with F_port trunking enabled. Persistently disabling port <Port that

is being disabled>.

Probable Cause Indicates that the speed is not compatible for F_port trunks.

Recommended

Action

Change the speed for the port or disable F_port trunking on the port.

Severity INFO

FABR-1041

Message <timestamp>, [FABR-1041], <sequence-number>,, ERROR, <system-name>, Port <Port

that is being disabled> is disabled due to trunk protocol error.

Probable Cause Indicates a link reset was received before the completion of the trunking protocol on the port.

Recommended

Action

Enable the port by running the portEnable command.

The port may recover by re-initialization of the link.

If the message persists, run the supportFtp command (as needed) to set up automatic FTP

transfers followed by the supportSave command and contact your switch service provider.

Severity ERROR

FABR-1043

Message <timestamp>, [FABR-1043], <sequence-number>,, ERROR, <system-name>, Detected

Fabric ID conflict with remote (not neighbor) switch <Switchname> (domain <Domain

ID>), FID <Fabric ID>. No local E-ports disabled.

Probable Cause Indicates that the remote switch has a Fabric ID conflict with the local switch. But no ports are

disabled because the remote switch is not adjacent to the local switch.

Recommended

Action

Make sure that all the switches in the fabric have the same Fabric ID or upgrade the switch

firmware to a VF-capable firmware.

Severity ERROR