Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 251
53-1002448-01
Chapter
36
FCPH System Messages
FCPH-1001
Message <timestamp>, [FCPH-1001], <sequence-number>, FFDC, CRITICAL, <system-name>,
<function>: <failed function call> failed, out of memory condition
Probable Cause Indicates that the switch is low on memory and failed to allocate new memory for a Fibre Channel
driver instance.
The function can only be " fc_create". This function creates a Fibre Channel driver instance.
The failed function call kmalloc_wrapper has failed. This function call is for kernel memory
allocation.
Recommended
Action
A nonbladed switch will automatically reboot. For a bladed switch, the active CP blade will
automatically failover and the standby CP will become the active CP.
Severity CRITICAL
FCPH-1002
Message <timestamp>, [FCPH-1002], <sequence-number>,, WARNING, <system-name>, Port <Port
Number> has been disabled since switch requires authentication when device
authentication policy is set to ON.
Probable Cause Indicates a device which does not support authentication has tried to log in to the switch when the
device authentication policy is in ON status on the switch.
Recommended
Action
Enable the authentication on the device or set the device authentication status to PASSIVE/OFF on
the switch if it is not mandatory. Use the authUtil command to change the device authentication
policy.
Severity WARNING
FCPH-1003
Message <timestamp>, [FCPH-1003], <sequence-number>,, WARNING, <system-name>, New port
<Port Number> has same Port WWN with old port <Port Number> as part of duplicate
Port WWN detection policy.
Probable Cause Indicates that this port is older port of same Port WWN of new port or device.