Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 267
53-1002448-01
FCR-1058
37
Investigate the other switch for more details. Run the errShow command on the other switch to
view the error log for additional messages.
Severity ERROR
FCR-1058
Message <timestamp>, [FCR-1058], <sequence-number>,, WARNING, <system-name>, Port <port
number> isolated due to mismatched configuration parameter; <segmentation
reason>.
Probable Cause Indicates that the specified port was isolated after segmentation caused by mismatched
configuration parameters or by domain ID assigned by the principal switch that did not match the
insistent domain ID of this port.
Recommended
Action
Check the switches on both ends of the link for a possible mismatch in switch or port configuration
parameters such as Operating Mode, E_D_TOV, R_A_TOV, Domain ID Offset, etc.
Run the portCfgExport command to modify the appropriate parameters on the local switch.
Run the appropriate configuration command to modify the switch or port parameters on the remote
switch.
Severity WARNING
FCR-1059
Message <timestamp>, [FCR-1059], <sequence-number>,, INFO, <system-name>, EX_Port <port
number> was disabled due to an authentication failure.
Probable Cause Indicates that the authentication, which uses the Diffie Hellman - challenge handshake
authentication Protocol (DH-CHAP), failed on the EX_Port.
Recommended
Action
Verify that the shared secrets on both sides of the link match.
Disable and enable the ports by using the portDisable and the portEnable commands to restart
authentication.
Severity INFO
FCR-1060
Message <timestamp>, [FCR-1060], <sequence-number>,, WARNING, <system-name>,
EX_Port(<port number>) has an incompatible configuration setting.
Probable Cause Indicates that virtual channel (VC) Link Init is enabled on the local switch and the remote switch is
negotiating in R_RDY mode. The fabric might not form properly.
Recommended
Action
Check the configuration on the local switch using the portCfgShow command to verify that the VC
Link Init is disabled, if the remote switch is configured in R_RDY mode or only capable of R_RDY
mode.