Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 271
53-1002448-01
FCR-1071
37
FCR-1071
Message <timestamp>, [FCR-1071], <sequence-number>,, INFO, <system-name>, Port <port
number> is changed from non FCR port to FCR port.
Probable Cause Indicates that the port became an EX_Port or VEX_Port.
Recommended
Action
No action is required.
Severity INFO
FCR-1072
Message <timestamp>, [FCR-1072], <sequence-number>,, INFO, <system-name>, Port <port
number> is changed from FCR port to non FCR port.
Probable Cause Indicates that the port is no longer an EX_Port or VEX_Port.
Recommended
Action
No action is required.
Severity INFO
FCR-1073
Message <timestamp>, [FCR-1073], <sequence-number>,, INFO, <system-name>, Switch with
domain ID <domain ID> in fabric <fabric ID> has lower limit of LSAN Zones
supported.
Probable Cause Indicates that an earlier version of the switch in the backbone or edge that supports a different
limit of logical storage area network (LSAN) zones was detected.
Recommended
Action
Use the fcrResourceShow command on all Fibre Channel Routers in the Meta-SAN to find the
lowest supported LSAN zone limits. Ensure that total number of LSAN zones in the Meta-SAN are
within the lowest supported limit of LSAN zones.
Severity INFO
FCR-1074
Message <timestamp>, [FCR-1074], <sequence-number>,, ERROR, <system-name>, HA sync lost
as remote CP supports only <LSAN count> LSAN Zones.
Probable Cause Indicates that the remote control processor (CP) has older firmware, which only supports a lower
number of logical storage area network (LSAN) zones. This is causing the loss of the
high-availability (HA) sync.