Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 323
53-1002448-01
FICU-1007
39
FICU-1007
Message <timestamp>, [FICU-1007], <sequence-number>,, WARNING, <system-name>, <function
name>: Failed to allocate memory while performing <message>.
Probable Cause Indicates that memory resources are low. This may be a transient problem.
Recommended
Action
Check the memory usage in the switch using the memShow command.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
Severity WARNING
FICU-1008
Message <timestamp>, [FICU-1008], <sequence-number>,, WARNING, <system-name>, FMS mode
has been enabled. Ports:<port numbers> have been disabled due to port address
conflict.
Probable Cause Indicates that the specified ports were disabled when FMS mode was enabled. This is due to a port
address conflict or the port address being reserved for the CUP management port.
Recommended
Action
No action is required.
Severity WARNING
FICU-1009
Message <timestamp>, [FICU-1009], <sequence-number>,, WARNING, <system-name>, FMS Mode
enable failed due to insufficient frame filtering resources on some ports.
Probable Cause Indicates that the frame filtering resources required to enable FMS mode were not available on
some of the ports.
Recommended
Action
Execute the perfDelFilterMonitor command to delete the filter-based performance monitors used
on all ports to free up the resources.
Severity WARNING
FICU-1010
Message <timestamp>, [FICU-1010], <sequence-number>,, WARNING, <system-name>, FMS Mode
enable failed due to port(s) with areas 0xFE or 0xFF is(are) connected to
device(s).
Probable Cause Indicates that FMS mode was not enabled because ports with 0xFE or 0xFF areas are connected to
the devices.