Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 339
53-1002448-01
Chapter
44
FSSM System Messages
FSSM-1002
Message <timestamp>, [FSSM-1002], <sequence-number>, SLOT cp-slot-number | CHASSIS, INFO,
<system-name>, HA State is in sync.
Probable Cause Indicates that the High Availability (HA) state of the active Control Processor (CP) is in
synchronization with the HA state of the standby CP. If the standby CP is healthy, the failover will be
nondisruptive.
Recommended
Action
No action is required.
Severity INFO
FSSM-1003
Message <timestamp>, [FSSM-1003], <sequence-number>,, WARNING, <system-name>, HA State
out of sync.
Probable Cause Indicates that the HA state of the active CP is out of synchronization with the HA state of the
standby CP. If the active CP failover occurs when the HA state is out of synchronization, the failover
is disruptive.
Recommended
Action
If this message was logged as a result of a user-initiated action (such as running the reBoot
command), no action is required.
Otherwise, execute the haSyncStart command on the active CP to resynchronize the HA state. If the
HA state does not synchronize, execute the haDump command to diagnose the problem.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
Severity WARNING
FSSM-1004
Message <timestamp>, [FSSM-1004], <sequence-number>,, INFO, <system-name>, Incompatible
software version in HA synchronization.
Probable Cause Indicates that the active CP and the standby CP in a dual CP system are running firmware that are
incompatible with each other. If the active CP fails, the failover will be disruptive.