Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 421
53-1002448-01
Chapter
46
HAM System Messages
HAM-1001
Message <timestamp>, [HAM-1001], <sequence-number>, SLOT cp-slpt-number | FFDC | CHASSIS,
FFDC, CRITICAL, <system-name>, Standby CP is not healthy, device <device name>
status BAD, Severity = <Log="YES" Class="NONE" Severity>.
Probable Cause Indicates that a standby control processor (CP) device error is reported by the High Availability
Manager (HAM) Health Monitor, with the specified device and Log="YES” Class=”NONE" Severity
level. The Severity variable can be critical, major, or minor.
The active CP will continue to function normally, but because the standby CP is not healthy,
non-disruptive failover is not possible.
Recommended
Action
Restart the standby CP blade by ejecting the card and reseating it. If the problem persists, replace
the standby CP.
Severity CRITICAL
HAM-1002
Message <timestamp>, [HAM-1002], <sequence-number>, SLOT cp-slot-number | CHASSIS, INFO,
<system-name>, Standby CP is healthy.
Probable Cause Indicates that all the standby CP devices monitored by the HAM Health Monitor reported no error.
Recommended
Action
No action is required.
Severity INFO
HAM-1004
Message <timestamp>, [HAM-1004], <sequence-number>, SLOT cp-slot-number | CHASSIS, INFO,
<system-name>, Processor rebooted -
<Reboot Reason>.
Probable Cause Indicates that the switch has been restarted because of a user action or an error. The switch
restart can be initiated using the firmwareDownload, fastBoot, haFailover, and reboot commands.
Some examples of errors that may initiate this message are hardware errors, software errors,
compact flash errors, or memory errors. The Reboot Reason variable can be any of the following:
• Hafailover
• Reset
• Fastboot