Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)
Fabric OS Message Reference 423
53-1002448-01
HAM-1007
46
Recommended
Action
The standby CP will take over and reset the active CP. The system will be non-redundant because
the standby CP becomes the active CP.
Severity CRITICAL
HAM-1007
Message <timestamp>, [HAM-1007], <sequence-number>, SLOT cp-slpt-number | FFDC | CHASSIS,
FFDC, CRITICAL, <system-name>, Need to reboot the system for recovery, reason:
<reason name>.
Probable Cause Indicates that the switch in current condition needs to be restarted to achieve a reliable recovery.
The reasons can be one of the following:
• The standby CP was not ready when failover occurred.
• The failover occurred when the last Logical switch (LS) transaction was incomplete.
• The switch failed when timeout occurred at certain stage.
• The cold or warm recovery has failed.
Recommended
Action
If auto-reboot is enabled, the switch will automatically restart. Otherwise, execute the reboot
command to manually restart the switch.
Severity CRITICAL
HAM-1008
Message <timestamp>, [HAM-1008], <sequence-number>, SLOT cp-slpt-number | FFDC | CHASSIS,
FFDC, CRITICAL, <system-name>, Rebooting the system for recovery - auto-reboot is
enabled.
Probable Cause Indicates that the recovery by auto-reboot is enabled, and therefore the switch automatically
restarts. This message is displayed if the event logged in HAM-1007 has occurred and auto-reboot
is enabled.
Recommended
Action
Wait until the switch is up to perform any operations.
Severity CRITICAL
HAM-1009
Message <timestamp>, [HAM-1009], <sequence-number>, SLOT cp-slpt-number | FFDC | CHASSIS,
FFDC, CRITICAL, <system-name>, Need to MANUALLY REBOOT the system for recovery -
auto-reboot is disabled.
Probable Cause Indicates that the recovery by auto-restart is disabled, therefore the switch needs to be manually
restarted for recovery. This message is displayed if the event logged in HAM-1007 has occurred
and auto-reboot is disabled.