Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

712 Fabric OS Message Reference
53-1002448-01
SWCH-1018
102
Recommended
Action
This is a LOOP device and peristent PID is set on it. This is not a supported configuration. Remove
the WWN-PID binding and re-enable the port and then run the wwnaddress
--unbind wwn
command.
Severity INFO
SWCH-1018
Message <timestamp>, [SWCH-1018], <sequence-number>,, INFO, <system-name>, Device <wwn
name of device> flogis to port <port number>, Static persistent PID set, Requested
area <area> user bound to another port. Reject FLOGI.
Probable Cause Indicates WWN-PID and PortAddress binding collision.
Recommended
Action
The Peristent PID is set on device and requested area cannot be assigned as its user is bound to a
different port. Remove the WWN-PID binding or remove portAddress binding and re-enable the port
and then run the wwnaddress
--unbind wwn or portaddress --unbind slot/port command.
Severity INFO
SWCH-1019
Message <timestamp>, [SWCH-1019], <sequence-number>,, INFO, <system-name>, Device <wwn
name of device> tries to flogi, reject FLOGI as persistent PID is set on device
and port <port number> has user area <area> bound to it.
Probable Cause Indicates a WWN-PID and PortAddress binding collision.
Recommended
Action
The Peristent PID is set on the device and requested area cannot be assigned because its user is
bound to a different port. Remove the WWN-PID binding or remove portAddress binding and
re-enable the port and then run the wwnaddress
--unbind wwn or portaddress --unbind slot/port
command.
Severity INFO
SWCH-1020
Message <timestamp>, [SWCH-1020], <sequence-number>,, WARNING, <system-name>, HA state
out of sync: Standby CP (ver = <standby SWC version>) does not support QOS links
to AG (Active CP version = <active SWC version>).
Probable Cause Indicates the standby control processor (CP) does not support links to AG running QOS.
Recommended
Action
Load a firmware version on the standby CP that supports QOS links to AG, using the
firmwareDownload command.
Severity WARNING