Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 713
53-1002448-01
SWCH-1021
102
SWCH-1021
Message <timestamp>, [SWCH-1021], <sequence-number>,, WARNING, <system-name>, HA state
out of sync: Standby CP (ver = <standby SWC version>) does not support Dynamic
area on default switch (Active CP version = <active SWC version>).
Probable Cause Indicates the standby control processor (CP) does not support dynamic area on default switch.
Recommended
Action
Load a firmware version on the standby CP that supports dynamic area on default switch, using the
firmwareDownload command.
Severity WARNING
SWCH-1022
Message <timestamp>, [SWCH-1022], <sequence-number>,, WARNING, <system-name>, Port:<port
number> have been disabled due to port address conflict while enabling FMS mode.
Probable Cause Indicates the switch has ports with FMS reserved areas (0xFE or 0xFF) which are not supported in
FMS mode.
Recommended
Action
This is a normal event; no action is required.
Refer to the Fabric OS Administrator's Guide for more information.
Severity WARNING