Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

754 Fabric OS Message Reference
53-1002448-01
ZONE-1005
115
Recommended
Action
No action is required.
Severity INFO
ZONE-1005
Message <timestamp>, [ZONE-1005], <sequence-number>,, INFO, <system-name>, HARD and SOFT
zones(<Zone name>, <Zone name>) definitions overlap.
Probable Cause Indicates that a port is zoned with mixed devices (WWN and D,I). During zoning database cross
checking, either of the following is detected:
• A port zone member is also listed as a member of a Mixed zone.
• A WWN zone member is also specified as a member of a Mixed zone.
Use hard zone enforcement whenever possible. Hard zones are more secure than session-based
hard zones. Both types of zones trap a PLOGI, but hard zones filter out the I/O frames which
session-based hard zones do not.
Recommended
Action
If hard zone enforcement is preferred, edit the zoning database to have the port zoned with devices
defined as WWN or D,I, but do not mix the methods used to define these zone members.
Severity INFO
ZONE-1006
Message <timestamp>, [ZONE-1006], <sequence-number>,, WARNING, <system-name>, WWN (<WWN
number>)in HARD PORT zone <zone_name>.
Probable Cause Indicates that one or more devices are zoned as WWN and D,I devices. The devices are used to
specify zone members over separate zones.
Recommended
Action
If hardware zoning enforcement is preferred, edit the zoning database to have the device zoned
using only one specification type: WWN or D,I.
Severity WARNING
ZONE-1007
Message <timestamp>, [ZONE-1007], <sequence-number>,, INFO, <system-name>,
Ioctl(<function>) in (<error message>) at port (<port number>) returns code
(<error string>) and reason string (<reason string>).
Probable Cause Indicates that frame filter logic reported a failure during the specified I/O Control (IOCTL) call. This
is usually a programming error when adding CAM entries before the filter setup.