Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 765
53-1002448-01
ZONE-1048
115
ZONE-1048
Message <timestamp>, [ZONE-1048], <sequence-number>,, WARNING, <system-name>, ZONE ACA is
rejected on the standby.
Probable Cause Indicates that the standby zoning component did not receive a syncdump command from the
primary side.
Recommended
Action
Synchronize the standby control processor (CP) using the haSyncStart command.
Severity WARNING
ZONE-1049
Message <timestamp>, [ZONE-1049], <sequence-number>,, ERROR, <system-name>, ZONE
AD-DefZone conflict detected while system initialization.
Probable Cause Indicates that there is an Admin Domain (AD) Default Zone conflict.
Recommended
Action
Verify that the default zoning mode for AD0 is set to No Access using the defzone
--show
command. If the default zoning mode is not set to No Access, execute the defzone
--noaccess
command and then execute the cfgsave command to commit the default zone mode change.
Severity ERROR
ZONE-1050
Message <timestamp>, [ZONE-1050], <sequence-number>,, INFO, <system-name>, The Interop
Safe Zoning mode is set to Enabled.
Probable Cause Indicates that the Interop Safe Zoning mode is enabled.
Recommended
Action
Verify the event was planned. If the event was planned, no action is required. If the event was not
planned, take appropriate action as defined by your enterprise security policy.
Severity INFO
ZONE-1051
Message <timestamp>, [ZONE-1051], <sequence-number>,, INFO, <system-name>, The Interop
Safe Zoning mode is set to Disabled.
Probable Cause Indicates that the Interop Safe Zoning mode is disabled.
Recommended
Action
Verify if the Safe Zoning mode change was done on purpose.
Severity INFO