Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 767
53-1002448-01
ZONE-1056
115
ZONE-1056
Message <timestamp>, [ZONE-1056], <sequence-number>,, WARNING, <system-name>,
Non-ETIZ-Capable Switch (dom <domainID>) in fabric w/ETIZ Configured.
Probable Cause Indicates that the cfgSave, cfgEnable, or cfgDisable commands will not work on the Fabric OS
switch earlier than v6.4.0 in Interop Mode 2 (IM2) fabric when Enhanced/Overlapping TI zones
(ETIZs) are configured.
Recommended
Action
Remove Fabric OS switch earlier than v6.4.0 from the fabric or delete the enhanced Traffic
Isolation (TI) zones using the zone --delete name command.
Severity WARNING
ZONE-1057
Message <timestamp>, [ZONE-1057], <sequence-number>,, WARNING, <system-name>, TI Zone <TI
zone name> has domain <Domain ID of switch with version pre6.4.0> running pre
FOS6.4.0 firmware. TI member (Domain <Domain ID of higher port index>, Index
<Higher port index>) is not supported.
Probable Cause Indicates that an unsupported port index(> 511) is present in the TI zone path or the routing may
not be set up correctly.
Recommended
Action
Remove the port index from the TI zone using the zone --remove name command.
Severity WARNING
ZONE-1058
Message <timestamp>, [ZONE-1058], <sequence-number>,, WARNING, <system-name>, Domain
<Domain ID of the switch that becomes unreachable> present in TI zone <TI zone
name> became unreachable due to failover disabled mode.
Probable Cause Indicates that the domain present in the TI zone path is unreachable. This occurs if the TI zone
paths are unavailable or the TI zone is set up incorrectly.
Recommended
Action
Verify that the paths defined by TI zones are online or remove the domain from the TI zone using
the zone --delete name command.
Severity WARNING