Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

780 Fabric OS Message Reference
53-1002448-01
AUTH-3007
118
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity INFO
AUTH-3007
Message <Sequence Number> AUDIT, <timestamp>, [AUTH-3007], INFO, SECURITY,
<event-initiator-details>, <event-location>, , Event: <Event Name>, Status:
failed, Info: Port <port number> disabled due to receiving an authentication
reject with code '<Reason String>' and explanation '<Explanation String>'.
Probable Cause Indicates that the specified port was disabled due to receiving an authentication reject response
from the connected switch/device.
The error might indicate that an invalid entity attempted to connect to the switch.
Recommended
Action
Check the connection port for a possible security attack.
Check the shared secrets using the secAuthSecret command and reinitialize authentication using
the portDisable and portEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity INFO
AUTH-3008
Message <Sequence Number> AUDIT, <timestamp>, [AUTH-3008], INFO, SECURITY,
<event-initiator-details>, <event-location>, , Event: <Event Name>, Status:
failed, Info: Port <port number> has been disabled due to authentication failure
with code '<Reason String>' and explanation '<Explanation String>'.
Probable Cause Indicates that the specified port has been disabled, because the connecting switch/device failed to
authenticate.
The error might indicate that an invalid entity attempted to connect to the switch.
Recommended
Action
Check the connection port for a possible security attack.
Check the shared secrets using the secAuthSecret command and reinitialize authentication using
the portDisable and portEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity INFO