Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

864 Fabric OS Message Reference
53-1002448-01
SULB-1034
137
SULB-1034
Message <Sequence Number> AUDIT, <timestamp>, [SULB-1034], ERROR, FIRMWARE,
<event-initiator-details>, <event-location>, Relocation of internal image timed
out.
Probable Cause Indicates there may be an error caused by a switch initialization issue after the internal image is
relocated. It may also be caused by an internal Ethernet issue or by persistent storage failure.
Recommended
Action
Reboot the switch. This will cause the internal image to be relocated again. Use the
firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your
switch service provider.
Severity ERROR
SULB-1035
Message <Sequence Number> AUDIT, <timestamp>, [SULB-1035], ERROR, FIRMWARE,
<event-initiator-details>, <event-location>, , An error has occurred during
relocation of the internal image.
Probable Cause Indicates an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or
persistent storage hardware failure.
Recommended
Action
Reset the switch. This will cause the internal image to be relocated again. If the problem persists,
contact your switch service provider.
Severity ERROR
SULB-1037
Message <Sequence Number> AUDIT, <timestamp>, [SULB-1037], ERROR, FIRMWARE, HCL failed.
Reboot the switch manually using the reboot command. However, it will disrupt the
FC traffic.
Probable Cause Indicates HCL has failed. Many reasons, such as domain not confirmed, can cause this failure.
Recommended
Action
Run the reboot command to reboot the switch manually.
Severity ERROR