Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

Fabric OS Message Reference 865
53-1002448-01
SULB-1038
137
SULB-1038
Message <Sequence Number> AUDIT, <timestamp>, [SULB-1038], WARNING, FIRMWARE, Co-CPU has
not booted up properly. Skip the firmwaredownload command on the co-CPU.
Probable Cause Indicates that the Main CPU cannot access the co-CPU to update the firmware on the co-CPU or run
any other firmwaredownload command on the co-CPU. If firmwareDownload in progress it will
continue without updating the co-CPU firmware.
Recommended
Action
After firmwaredownload completes, reboot the CP manually to bring up the co-CPU and run the
firmwareDownload command again. If the problem persists, contact the service provider.
Severity WARNING
SULB-1039
Message <Sequence Number> AUDIT, <timestamp>, [SULB-1039], INFO, FIRMWARE, CP has
completed relocating the internal firmware image.
Probable Cause Indicates that the firmwareDownload command process has been completed normally on the CP.
Recommended
Action
Run the firmwareShow command to verify the firmware versions.
Severity INFO
SULB-1040
Message <Sequence Number> AUDIT, <timestamp>, [SULB-1040], WARNING, FIRMWARE,
<event-initiator-details>, <event-location>, , An error has occurred during
relocation of the internal image on the CP.
Probable Cause Indicates an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet
failure.
Recommended
Action
Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload
command again if the firmware is not updated.
This will cause the internal image to be relocated again. If the problem persists, contact your switch
service provider.
Severity WARNING