HP StorageWorks Fabric OS 5.3.1 release notes (AA-RWEYI-TE, March 2008)

Closed defect summary
Solution
When supportsave isruninacontinuousloop,certaintypesof
files are not detected which periodically generates the message:
SupportSave completed sh: /tmp/support-
Save_files/CONSOLE0: No such file or directory.
File name can vary .
Fixed in Fabric OS 5.3.0b.
When the SFP/XFP power and voltage readings are above or below
the range, an excessive number of alert messages were reported.
Fixed in Fabric OS 5.3.0b.
Third-party application will not work with the 400 MP Router Fast
Write application (sends FCP_RSP without sequence initiative).
Fixed in Fabric OS 5.3.0b.
On the B-Seri
es MP Router Blade or 400 MP Router, the proxy PID is
improperly c
onverted to 000000 for an ACC to a REC extended link
request when
an EX_Por t is configured for intero p mode. As a result,
Tape backup may not work with devices in McDATA edge fabrics
across the Router due to an improper response to a REC extended
link request to a tape device.
Fixed in Fabric OS 5.3.0b.
Fabric OS 5
.3.0c fixes
Table 6 lists defects closed in the Fabric OS 5.3.0c firmware release.
Table 6 Fabric OS 5.3.0c c losed defects
Closed defect summary
Solution
I/O Ops failure due to incorrect CUP Port PDCM bit for port 256 after
firmwareupgrade from FOS v5.1.x to FOSv5.2.x/5.3.x in FICON
environment.
Fixed in Fabric OS 5.3.0c.
With McDA
TA edge switches in the fabric, 400 MP Router or FR4-18i
router port receives periodic RRQ & ABTS frames due to the McDATA
switch sending unsupported CT command. Routers don’t respond,
which ca
uses McDATA switch to retry indefinitely.
Fixed in Fabric OS 5.3.0c to reject
the unsupported CT command.
After switchdisable & switchenable,all400MPRouters
or FR4-18i routers, proxydevices and nameserver entries no longer
match what was previously recorded. "fcrrproxydevshow -a" shows 0
devices and translate domains are missing from the e dge fabric. This
is due to a timing issu e while in open fabric interop mode with i10k
switch when 2nd IFL is connected to the same switch in the fabric as
the 1st IFL, and 1st IFL is fully up.
Fixed in Fabric OS 5.3.0c.
Hosts lose paths to targets due to FCR daemon failing to send
GA_NXT response from 400 MP Router to host connecting to
McDATA switch in open fabric mode. Caused by incorrect domain
offset in its address translation.
Fixed in Fabric OS 5.3.0c.
When FRU in a 4/256 Director is inserted/removed a
fruHistoryTrap should be generated, but is not.
Fixe
d in Fabric OS 5.3.0c. Note
that
fruStatusChangeTrap
wil
lnotbegeneratedwithFRU
insert/remove.
26