Brocade Fabric OS FCIP Administrator's Guide v7.1.0 (53-1002748-01, March 2013)

14 Fabric OS FCIP Administrator’s Guide
53-1002748-01
FX8-24 blade license options
2
or
portcfg ipif 8/xge0 create 192.168.11.20 255.255.255.0 1500 –x
Delete the crossport address using the delete option instead of the create option for the portcfg ipif
command.
portcfg ipif 8/xge0 delete 192.168.11.20 255.255.255.0 1500 –x
NOTE
If the crossport or x option is not specified and the address is on the crossport, the command will
fail with an unknown IP address. The command will also fail if the crossport option is specified and
the address is not on the crossport.
Display local and crossport interface configuration details for a specific XGE port using the
portshow ipif slot/xge<port> command. Use the portshow ipif all command to display details for all
interfaces.
portshow ipif 8/xge0
portshow ipif all
NOTE
For more information on using Fabric OS commands, optional arguments, and command output
refer to the Fabric OS Command Reference Manual.
Configuring 10GbE lossless failover with crossports
Refer to “10GbE Lossless Link Loss” on page 20.
Configuring IP routes with crossports
You can configure IP routes with crossport addresses, as in the following example. In the example,
the route will be available for FCIP tunnel circuits using VE ports 12 through 21.
portcfg iproute 8/xge0 create 1.1.1.0 255.255.255.0 192.168.11.250 --crossport
or
portcfg iproute 8/xge0 create 1.1.1.0 255.255.255.0 192.168.11.250 –x
Delete the route using the delete option instead of the create option for the portcfg iproute
command.
portcfg iproute 8/xge0 delete 1.1.1.0 255.255.255.0 -x
NOTE
If the crossport or x option is not specified and the address is on the crossport, the command will
fail with an unknown IP address. The command will also fail if the crossport option is specified and
the address is not on the crossport.
Display IP route information for the local interface and crossport using the portshow iproute
command:
switch:admin> portshow iproute 1/xge0
Display the IP interface and static route configured for crossports using the portshow ipif
command:
switch:admin> portshow ipif 1/xge0