Brocade Network Advisor SAN Installation and Migration Guide v12.0.0 (53-1002801-01, March 2013)

Network Advisor SAN Installation and Migration Guide 13
53-1002801-01
Chapter
2
Network Advisor Configuration
In this chapter
•Configuring Network Advisor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
•Accessing the Network Advisor interfaces. . . . . . . . . . . . . . . . . . . . . . . . . . . 19
•Syslog troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
•Installing the ODBC driver. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
•Smart Card driver installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
•Configuring an explicit server IP address. . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
•Configuring remote client access to the database . . . . . . . . . . . . . . . . . . . . 32
Configuring Network Advisor
If you have not installed the application, refer to “Installation” on page 1. If you are migrating data,
refer to “Data Migration” on page 33.
To configure Network Advisor, complete the following steps.
1. Click Next on the Welcome screen.
2. Click No, don’t any copy data and settings on the Copy Data and Settings (Migration) screen
and click Next.
NOTE
You cannot migrate data to Network Advisor 12.0.X after you complete configuration.
To migrate data from a previous management application version, refer to “Data Migration” on
page 33.