Brocade Network Advisor SAN Installation and Migration Guide v12.0.0 (53-1002801-01, March 2013)

Network Advisor SAN Installation and Migration Guide 17

53-1002801-01

Configuring Network Advisor

9. Complete the following steps on the Server Configuration screen (Figure 1).

NOTE

Do not use port 1527 for any of these port numbers. Port 1527 is used internally by the server.

FIGURE 1 Server Configuration screen

a. Enter a port number in the Web Server Port # (HTTPS) field (default is 443).

b. Enable HTTP redirection to HTTPS by selecting the Redirect HTTP Requests to HTTPS

check box.

When you enable HTTP redirection, the server uses port 80 to redirect HTTP requests to

HTTPS. You can configure the server port settings from the Options dialog box (Server Port

pane). For instructions, refer to the Network Advisor User Manual or online help.

c. Enter a port number in the Database Port # field (default is 5432).

NOTE

Do not use a port number below 1024.

d. Enter a port number in the Starting Port Number field (default is 24600).

NOTE

For Professional software, the server requires 15 consecutive free ports beginning with

the starting port number.

NOTE

For Trial and Licensed software, the server requires 18 consecutive free ports beginning

with the starting port number.

e. Enter a port number in the Syslog Port Number field (default is 514).

NOTE

If the default syslog port number is already in use, you will not receive any syslog

messages from the device. To find and stop the process currently running on the default

Syslog port number, refer to “Syslog troubleshooting” on page 22.