Brocade Network Advisor SAN Installation and Migration Guide v12.0.0 (53-1002801-01, March 2013)

28 Network Advisor SAN Installation and Migration Guide
53-1002801-01
Smart Card driver installation
2
5. Create a soft link into the system directory. This is to support the automatic restart of the pcscd
daemon upon system restart.
If you installed the pcsc directory into the /opt directory, just create the soft link. Otherwise,
use the name of the new directory in place of /opt.
S.u.s.e> ln –s /opt/pcsc/pcscctl /etc/init.d/pcscd
S.u.s.e> chkconfig --add pcscd
or
redhat> ln –s /opt/pcsc/pcscctl /etc/init.d/pcscd
redhat> chkconfig --add pcscd
NOTE
Before you enter chkconfig --add pcscd, you can enter chkconfig –list | grep pcscd to verify
that the pcscd file is already on the list. If it already exists, you do not need to enter
chkconfig –add pcscd. After you reboot the system, you should expect the following links
under /etc/rc2.d, /etc/rc3.d, /etc/rc3.d, /etc/rc4.d, and /etc/rc5.d.
lrwxrwxrwx 1 root root 15 Jul 28 01:50 S94pcscd -> ../init.d/pcscd
NOTE
For some Linux vendors, the Smart Card driver may come with the operating system. In
this case, extra system configuration may be needed. For more information, refer to
“Detecting and correcting a default Linux Smart Card driver” on page 29.
6. Start the pcscd daemon or stop the pcscd daemon.
To start pcscd, type:
> /opt/pcsc/pcscctl start
To stop pcscd, type:
> /opt/pcsc/pcscctl stop