Manualshelf

Brocade Network Advisor SAN Installation and Migration Guide v12.0.0 (53-1002801-01, March 2013)

ManualsBrandsHP ManualsStorageHP StoreFabric SN6500B 16Gb 96/96 Power Pack+ FC Switch
51525354555657585960
44 Network Advisor SAN Installation and Migration Guide
53-1002801-01
Migrating data
3
f. Enter a port number in the SNMP Port # field (default is 162).
g. Click Next.
If you enter a syslog port number already in use, a message displays. Click No on the
message to remain on the Server Configuration screen and edit the syslog port number.
Click Yes to close the message and continue with
step 11.
If you enter a port number already in use, a warning displays next to the associated port
number field. Edit that port number and click Next.
If you are configuring Professional software, go to step 13.
11. Complete the following steps on the SMI Agent Configuration screen.
a. Enable the SMI Agent by selecting the Enable SMI Agent check box.
b. Enable the SLP by selecting the Enable SLP check box, if necessary.
Only enabled after you select the Enable SMI Agent check box.
c. Enable the SSL by selecting the Enable SSL check box, if necessary.
Only enabled after you select the Enable SMI Agent check box.
d. Enter the SMI Agent port number in the SMI Agent Port # field (default is 5989 if SSL
Enabled is selected; otherwise, the default is 5988).
e. Click Next.
12. Select one of the following options on the SAN Network Size screen and click Next:
NOTE
Port count is equal to the total number of switch ports across all fabrics.
NOTE
If you installed the SAN with SMI Agent package on a 32-bit Windows system, the Large option
is disabled for SAN Network Size (Enterprise).
• Small (managing up to 2000 switch ports, 1-20 domains)
• Medium (managing up to 5000 switch ports, 21-60 domains)
• Large (managing up to 9000 switch ports, 61-120 domains)
13. Verify your configuration information on the Server Configuration Summary screen and click
Next.
14. Complete the following steps on the Start Server screen.
a. (Trial and Licensed only) Select the Start SMI Agent check box, if necessary.
b. (Trial and Licensed only) Select the Start SLP check box, if necessary.
c. Select the Start Client check box, if necessary.
d. Click Finish.
After all of the services are started, the Log In dialog box displays.
To make changes to the configuration, you can re-launch the configuration wizard (refer to
“Configuring an explicit server IP address” on page 31).