HP Store Once Backup System 4900 Installation and Configuration Guide

5 Configuration using the system set config wizard
The StoreOnce CLI command set provides two configuration wizards:
The system set config command sequence packages a number of commands, some of
which you may skip, if required. This wizard is recommend if you wish to configure time and
license settings at the same time as network settings and run a health check. The network
configuration element of this wizard uses the net set wizard command.
The net set wizard command sequence configures network settings and is described in
detail in Network configuration, how to use StoreOnce CLI commands (page 45).
Abstract
It is recommended that you read Network configuration, understanding the concepts (page 38)
before running either wizard for the first time.
System configuration using system set config command
The StoreOnce CLI wizard, system set config command sequence packages a number of
commands, some of which you may skip, if required.
Before running the wizard collect and verify the required network information, see Before running
net set wizard (page 45).
Four actions are available at each step, as shown in the example below; execute, skip, back
and quit. (The network must be configured.)
# system set config
The following configuration steps will be performed.
>Configure Network
Configure Time
Configure Licenses
Verify Hardware health
Finish Configuration and reboot
Finish Configuration
Actions:
execute) Perform current step (Default)
skip) Skip to the next step
back) Go back to a previous step
quit) Exit the configuration immediately
Each of the configuration steps listed above in the wizard is now described in more detail.
Configure network
This step runs through the network configuration and is equivalent to running the net set wizard
command. This step must be completed.
The wizard guides you through the network configuration on the StoreOnce Backup system. It
configures all network settings for all subnets.
NOTE: See Network configuration using net set wizard (page 48) for an example net set
wizard sequence.
Configure Time
This step allows you to set the time explicitly or set it using NTP server. If you select NTP server you
will be asked to specify up to two NTP server names (or IP addresses) and select the timezone.
You may skip this step and configure time later. See Setting up time and date (page 63).
36 Configuration using the system set config wizard