HP Store Once Backup System 4900 Installation and Configuration Guide

Select the type of configuration for this subnet
(Selecting "bonded" here will create a "portset" consisting of two separate NICs bonded together) :
1 = Single port (default)
2 = Bonded ports (note ports must be the same speed to bond)
-->1
<--Bonded/Single: Single port
Select network adapter :
1 = eth0 (1 Gig) (default)
2 = eth1 (1 Gig)
3 = eth2 (1 Gig)
4 = eth3 (1 Gig)
5 = eth4 (10 Gig)
6 = eth5 (10 Gig)
-->1
<--Single Port: eth0 (1 Gig)
---------------------------------------------------
The next question has a mandatory response, since
this is a single-node system.
---------------------------------------------------
What type of data will this network carry?
1 = both (default)
-->1
<--Data/Management/Both: both
Is this subnet on a Virtual LAN?
1 = No (default)
2 = Yes
-->1
<--VLAN/Not VLAN: No
Select Static or DHCP addressing :
1 = DHCP (default)
2 = Static
-->1
<--DHCP/Static: DHCP
Do you want to configure a static default gateway for this subnet or get the gateway information from
DHCP?
1 = Gateway obtained from DHCP server (default)
2 = Set gateway manually (this may be blank if no gateway is required)
-->1
<--Gateway: Gateway obtained from DHCP server
Do you want to configure the network domain name or get the domain name from DHCP?
1 = Domain name obtained from DHCP server (default)
2 = Set domain name manually (e.g. mydomain.local - this may be blank if no domain name is required)
-->1
<--Domain Name: Domain name obtained from DHCP server
----------------------
Network: subnet_1
----------------------
IP Addresses: dhcp
Net Mask: dhcp
Domain Name: dhcp
Gateway: dhcp
VLAN tag:
Port Set: portset_1 with these interfaces: eth0
Encryption Links:
Bonding Mode: Not applicable
Is this configuration correct?
1 = Yes (default)
2 = No
-->1
<--Configuration okay: Yes
-------------------------------------------------------------
If you have added all subnets, then you may proceed: you will
then be shown a summary of the configuration and be given the
option to validate it, and then a further option to apply it.
Otherwise, you may continue to add further subnets.
-------------------------------------------------------------
Do you want to configure another subnet?
50 Network configuration, how to use StoreOnce CLI commands