HP Store Once Backup System 4900 Installation and Configuration Guide

ipaddr 10.2.1.55 gateway 10.2.1.1 netmask 255.255.0.0 domain sales.mycompany.net
nl
default no vlantag 23
Command Successful
4. Check the configuration again.
# net show config ACMECorpNetwork1
----------------------
Network Name: ACMECorpNetwork1
Network Description: Created by wizard on: Wed Apr 30 15:26:40 2014
Write Protected: no
DNS Servers: 172.1.1.100 172.1.2.100
Port Sets: portset_1 portset_2 portset_3
----------------------
Number of Networks: 4
Number of VLANs configured: 2 out of possible 128
----------------------
Network: subnet_1
----------------------
IP Addresses: dhcp
Net Mask: dhcp
Domain Name: dhcp
Gateway: dhcp
Default Network:
VLAN tag:
Port Set: portset_1 with these interfaces: eth0
Encryption Links:
Bonding Mode: Not applicable----------------------
Network: subnet_2
----------------------
IP Addresses: 10.1.1.21
Net Mask: 255.255.0.0
Domain Name: rnd.mycompany.net
Gateway: 10.1.1.1
Default Network:
VLAN tag: 22
Port Set: portset_2 with these interfaces: eth5 eth7
Encryption Links:
Bonding Mode: 4 (Link Aggregate Control Protocol (LACP) Bonding)
----------------------
Network: subnet_3
----------------------
IP Addresses: 172.1.1.66
Net Mask: 255.255.0.0
Domain Name: uk.mycompany.net
Gateway: 172.1.1.1
Default Network: yes
VLAN tag:
Port Set: portset_3 with these interfaces: eth2 eth3
Encryption Links:
Bonding Mode: 6 (Active Load Balance Bonding)
----------------------
Network: SalesSubnet
----------------------
IP Addresses: 10.2.1.55
Net Mask: 255.255.0.0
Domain Name: sales.mycompany.net
Gateway: 10.2.1.1
Default Network: no
VLAN tag: 24
Port Set: portset_2 with these interfaces: eth5 eth7
Encryption Links:
Bonding Mode: 4 (Link Aggregate Control Protocol (LACP) Bonding)
Command Successful
58 Network configuration, how to use StoreOnce CLI commands