HP Store Once Backup System 4900 Installation and Configuration Guide

For example, we have one 1GbE port unassigned, eth1. To add it after initial configuration we

would use the following procedure.

NOTE: We will not configure this subnet with the default gateway.

1. Create a new portset for the copied configuration. The StoreOnce CLI command is in the

format:

net create portset ACMECorpNetwork1 portset_4 ports eth1 vlansupport

2. Add a subnet to the portset. The StoreOnce CLI command is in the format:

# net add subnet ACMECorpNetwork1 subnet Subnet_4 portset portset_4

ipaddr 192.168.2.15 gateway 192.168.2.1 netmask 255.255.255.0 domain uk.mycompany.net default no

3. Validate the modified configuration using the StoreOnce CLI command:

net validate config <newconfig>

4. Activate the modified configuration using the StoreOnce CLI command:

net activate config <newconfig>

5. Once successfully validated and activated, the modified configuration becomes the current

configuration and overwrites the contents of the current configuration.

NOTE: If you wish to configure the remaining two 10GbE ports, a similar process applies.

62 Network configuration, how to use StoreOnce CLI commands