HP Store Once Backup System 4900 Installation and Configuration Guide

10 Configuring backup servers to work with HP StoreOnce
This chapter describes how to configure Tape drivers and iSCSI on Windows backup servers. If
working in a Linux or UNIX environment, refer to the separate HP StoreOnce Backup systems Linux
and UNIX Configuration guide.
In this chapter:
• Configuring Data in Flight encryption on Windows media servers (page 83)
• Driver installation (VTL only) (page 92)
• iSCSI Initiator (VTL only) (page 93)
Configuring Data in Flight encryption on Windows media servers
The following procedure describes how to configure Windows Server 2008 R2 and 2012 for use
with StoreOnce Data in Flight encryption.
For instructions on configuring encryption on the StoreOnce Backup system, see Adding encryption
to StoreOnce Backup system (page 60). For instructions on configuring encryption on Linux see
the HP StoreOnce Linux and UNIX Configuration guide.
NOTE: The settings for key lifetimes can have an impact on the performance of the data in flight
encryption links. If the lifetime values are set to low values, then there is a risk of low performances
or even failures of the backup jobs. It is recommended, that these values are set sufficiently high
to allow the backup jobs to run as well as maintain the security of the data being transferred
1. Open Windows Firewall with Advanced Security.
Go to Control Panel > System and Security > Administrative Tools > Windows Firewall with
Advanced Security.
Configuring Data in Flight encryption on Windows media servers 83