HP Store Once Backup System 4900 Installation and Configuration Guide

The recommended process if you wish to enable authentication is:
1. Create the devices on the StoreOnce GUI or CLI.
2. Set up the Targets in the iSCSI Initiator.
3. Connect to the devices using the CHAP user name and secret that you configured on the
Targets tab.
The Microsoft iSCSI Initiator
The Microsoft iSCSI initiator contains a number of tabs. This section describes the information that
must be provided in order to connect the host to a device on the HP StoreOnce Backup system. It
does not provide a comprehensive description of all the tabs; please download the “User Guide”
from the Microsoft website for more information.
NOTE: The screenshots below may not be correct for your operating system. They are taken from
an iSCSI Initiator running on a Windows 7 operating system.
1. The Targets tab is the default tab when you run the iSCSI Initiator for the first time. At this point
no targets have been discovered.
2. Select the Discovery tab. At this point there are no target portals.
94 Configuring backup servers to work with HP StoreOnce