HP StoreOnce VSA Backup System User Guide (TC458-96025)

Working with the Libraries list (top half of page)
The Libraries list in the top half of the page provides columns of details.
• To sort the list according to a column, click on the column heading and select Sort Ascending
or Sort Descending.
• To hide or show columns, click on any column heading, select Columns and uncheck or check
the preferred columns.
• Users with an Admin login may also create libraries. Click Create.
See Create a library (page 19) for more information.
• Users with an Admin login may edit details on some of the tabs for individual libraries (not
all tabs have editable information). The relevant GUI buttons are on the tab. For example,
each Edit button shall trigger edit mode only for the current tab. When in edit mode, each
tab shall have its own Update and Cancel buttons. If a user changes tab while in edit mode
a warning dialog advises that any changes they have made will be lost.
The Delete button is on the Device Details tab only and will delete the entire library.
Table 3 Libraries parameters (top half of page)
DescriptionParameter
Identifies the selected device (library). HP recommends usnig a name that identifies the
host or backup job with which it is associated.
Name
The role of the library, which may be non-replicating, replication source or replication
target.
Replication Role
The status of the library, which may be online, offline, notstarted, failed to start, stopping,
creating, or deleting.
Status
Indicates whether the library is connected. Possible values are: Connected – A client
device is connected to any device (robotics or drive) within this library. Not Connected
– No device is connected to this library.
Connection
The emulation type used by the backup software. It is selected when you create a device.Device Type
The number of cartridges or slots available on the device, which is determined by the
Emulation types for tape device selected when the device was created. You can reduce
Cartridges / Slots
the number of slots in the Device Details tab for a library selected on this page, but this
will only remove the highest empty slots. Once it reaches a slot number that contains
data, it will not allow you to reduce the number further on this page, even if earlier slots
are blank. You must first use the Cartridges tab to make the slot empty.
Identifies the port to which the host is connected for backup and restore. The number of
ports available in the drop-down menu depends upon the interfaces that your model
supports and your network configuration.
There is always one iSCSI port.
Port
The amount of user data stored on the library.User Data Stored
The actual size used on disk (after deduplication).Size On Disk
The deduplication ratio achieved on the data on the library. If deduplication is disabled,
the column displays “Dedupe Disabled.”
Dedupe Ratio
Device Details tab
This tab displays device-specific information for the selected library.
Users with an Admin login may perform the following tasks from this tab:
• Create a library (page 19)
• Edit a library (page 20)
Libraries page 17