HP StoreOnce VSA Backup System User Guide (TC458-96025)

Table 13 Source Appliances parameters
The serial number for the required Service Set. This information can be found on the
top-level HP StoreOnce page.
Serial Number
The name of the appliance for which you have specified the serial number and cannot
be altered.
Appliance Name
The status of the appliance for which you have specified the serial number and cannot
be altered.
Appliance Status
The address of the appliance for which you have specified the serial number and
cannot be altered.
Appliance Address
Indicates whether any mappings have been configured on the source appliance. This
is important because any mappings that already exist will be retained regardless of
Configured Mappings
any access permissions you subsequently set up for libraries and shares on that
appliance.
3. Click Add. A wizard prompts the necessary steps to add a new source appliance to the list.
Provide the serial number of the appliance and specify initial access permissions for all libraries
and all shares on that appliance.
4. Once the appliance is added to the list of Source Appliances, permissions can be configured
for it.
To configure permissions (administrators only)
1. Select the source appliance in the list. There are two tabs; one for Libraries, and one for
Shares.
2. Click Edit. Check the Access box for those shares and libraries to which access should be
granted. These are the shares and libraries that will be displayed when the mapping
configuration step is run in the Replication wizard. It will not be possible to create a new share
or library from the wizard.
3. Click Update to apply the permissions.
Local Settings (Replication) tab
This tab contains three additional tabs that show the settings for the local HP StoreOnce Backup
system:
• General Settings tab (page 58)
• Bandwidth Limiting tab (page 59)
• Blackout Windows tab (page 60)
Local Settings (Replication) tab 57