HP StoreOnce VSA Backup System User Guide (TC458-96025)

2. Reverse seed the first full restore. The simplest way to do this is to use a USB disk, as described
below. It is also possible to recover across the WAN, but this may place an unacceptable
load on bandwidth or time availability.
It is possible to reverse seed the first full restore using a USB disk, as follows:
• Map from the host at the target site to the NAS share on the HP StoreOnce Backup system
and copy the share to a USB disk attached to the host.
• Transport the media to the Replication Source site and attach it to a host.
• Map from a host at the source site to the new share on the Replication Source and copy
across the data from the USB disk before running the Recovery Wizard.
3. Go to the Replication—NAS Mappings page and select the new non-replicating share.
4. Click Start Recovery Wizard.
5. At the Select Target Appliance step, select Add Target Appliance and provide the IP address
of the previous replication target device.
6. Select the existing Target. This is the Target NAS share from which files should be recovered.
Click Next.
NAS Mappings (Replication) 77