HP StoreOnce Backup System Concepts and Configuration Guidelines (BB877-90913, November 2013)

The default bonding mode for this template is Mode 1, Active/Backup, on both sub-nets.

The recommended IP address range is 25 in total: 16 contiguous on the data sub-net; 1 + 8

contiguous on the management sub-net.

NOTE: When using a 10GbE network, you must provide the correct SFPs for your environment.

They are not supplied with the product.

Figure 16 Template 1 cabling to customer's networks

bonded 10 GbE ports, normally to customer's data sub-net1 and 2

bonded 1 GbE ports, normally to customer's management sub-net3 and 4

internal cabling, should not be removedblue cables

Template 2, uses 1GbE network only

Template 2 supports users who have a 1GbE network only. The same network is used for data

and management.

The default bonding mode for this template is Mode 6, Active Load Balancing.

The recommended IP address range is 17 in total: 1 for management and 16 contiguous for data.

NOTE: For software revision 3.3.0 and greater: customers who do not have a sufficient number

of physical Ethernet ports to support Template 2 should use Template 5 instead.

Figure 17 Template 2 cabling to customer's networks

bonded 1 GbE ports to customer's data and management network1, 2, 3 and 4

internal cabling, should not be removedblue cables

38 Network configuration in multi-node StoreOnce Backup systems