11.0 HP StoreVirtual Storage User Guide (AX696-96275, December 2013)

allowing multiple iSCSI application server connections
to a volume, 208, 245
before changing server connections and permissions,
210
changing RAID erases all data, 26
check Safe to Remove before replacing disk, 42
create SmartClone volume or Remote Copy before
rolling back snapshot, 174
decreasing volume size not recommended, 153
deleting management group causes data loss, 116
deleting volume permanently removes data, 161
disabling network interface, 68
do not defragment file system unless required, 153
do not delete individual snapshot from snapshot set,
177
do not delete last snapshot of Network RAID-5 or
Network RAID-6 volume, 177
iSCSI failover issues with noncompliant iSCSI initiator
with load balancing, 201
log into management group from one CMC only, 107
minimum configuration for fault tolerance, 144
plugging NICs into same switch for Link Aggregation
Dynamic Mode, 53
resetting storage system to factory defaults erases all
data and configuration information, 250
stop applications and log off iSCSI sessions before
deleting volumes or snapshots, 196
verify that NIC bond works properly, 64
virtual manager requires manual activation, 127
volumes with Network RAID-0 not protected from system
failure or reboot, 144
warnings when using DHCP, 52
when changing management group to normal mode,
115
when to log off before changing iSCSI server settings,
202
where to install Failover Manager, 122, 123
Centralized Management Console, setting up for remote
support, 13
Challenge Handshake Authentication Protocol see CHAP
changing
administrative group description, 79
changing RAID erases data, 26
cluster configuration, 134
clusters, for volumes, 160
data protection levels, 160
DNS domain name, 69
host names, 15
IP address of storage system, 52
local bandwidth, 113
maintenance mode to normal, 115
management groups, 113
network configuration, 47
order of NTP server access, 75
snapshots, 165
thresholds in a snapshot, 165
user password, 77
volume descriptions, 160
volume size, 160
CHAP
1-way, 242
2-way, 242
configuring with multi-byte character name, 243
editing, 202
iSCSI, 242
not required, 201
required, 201
requirements for configuring, 202, 243
terminology in different initiators, 243
using, 242
volumes and, 242
characteristics of SmartClone volumes, 183
checklist for disk replacement, 43
choosing a RAID configuration, 21
client access to volumes, 9
clients, adding SNMP, 93
clone see SmartClone volumes
clone a volume, 182
clone point
and shared snapshots, 189
deleting, 196
SmartClone volumes, 187
cluster swap, 137
Cluster Utilization Summary, customizing on SAN Status
Page, 84
cluster-level data protection, Best Practice Summary, 110
clustered application servers
changing volume associations after deleting server
cluster, 208
creating, 206
deleting cluster, 207
clustering application servers, 199, 206
clustering managers, 104
clustering servers, 199, 206
clusters
Adaptive Optimization and, 133
adding, 133
adding storage system, 135
capacity, 132
comparing the load of two, 217, 226
data protection levels, 143
deleting, 140
editing, 134
map view, 134
moving volumes between, 160
overview, 132
removing storage systems from, 137
reorder storage systems within, 136
repairing storage system in, 138
space reporting in, 149
swapping storage systems, 136
System Use window, 151
troubleshooting, 137
usable space in, 151
Use Summary window, 149
viewing capacity and useage of, 148
Volume Use window, 150
277