9.5.01 HP P4000 SAN Solution User Guide (AX696-96168, February 2012)

$ xterm
3. In the xterm window, start minicom as follows:
$ minicom -c on -l NSM
Opening the Configuration Interface from the terminal emulation session
1. Press Enter when the terminal emulation session is established.
2. Enter start, and press Enter at the log in prompt.
3. When the session is connected to the storage system, the Configuration Interface window
opens.
Logging in to the Configuration Interface
Once you have established a connection to the storage system, log in to the Configuration Interface.
Table 67 Logging in depends on where the storage system is
From Configuration Interface entry windowIf the storage system is in
Press Enter to log in. The Configuration Interface main menu
opens.
Available Systems pool
Management group 1. Press Enter to log in.
2. Enter the user name and password of the administrative
user created for the management group.
3. Tab to Login, and press Enter.
NOTE: This user is viewable in the CMC under the management group Administration category.
Configuring administrative users
Use the Configuration Interface to add new administrative users or to change administrative
passwords. You can only change the password for the administrative user that you used to log in
to the Configuration Interface.
1. On the Configuration Interface main menu, tab to General Settings, and press Enter.
2. To add an administrative user, tab to Add Administrator, and press Enter. Then enter the new
user’s name and password. Confirm password, tab to OK, and press Enter.
3. To change the password for the user that you are currently logged in as, tab to Change
Password, and press Enter. Then enter the new password. Confirm password, tab to OK, and
press Enter.
4. On the General window, tab to Done, and press Enter.
Configuring a network connection
The storage system comes with two Ethernet interfaces. Table 68 (page 236) lists where interfaces
are labeled and the label name.
Table 68 Identifying Ethernet interfaces on the storage system
Ethernet Interfaces
What the label saysWhere labeled
Name:TCP/IP Network configuration category in the CMC
• TCP/IP tab
eth0, eth1
Motherboard:Port0, Motherboard:Port1
• TCP Status tab
G4-Motherboard:Port1, G4-Motherboard:Port2
236 Using the Configuration Interface