9.5.01 HP P4000 SAN Solution User Guide (AX696-96168, February 2012)

Figure 35 Searching for the unbonded storage system on the network
5. Search for the storage system by Host Name or IP Address or Subnet/Mask.
NOTE: Because it can take a few minutes for the storage system to re-initialize, the search
may fail the first time. If the search fails, wait a minute or two and choose Try Again on the
Network Search Failed message.
You can also use the Configuration Interface to delete a NIC bond. See “Deleting a NIC
bond” (page 237).
Verify NIC settings and communication settings after deleting a bond
1. Select a storage system, and open the tree below it.
2. Select the TCP/IP Network category.
3. Check the interfaces on the TCP/IP tab, and reconfigure them if necessary.
After deleting a bond, the interfaces may not have the correct IP addresses, or one interface
may be disabled.
4. Click the Communication tab.
70 Managing the network